Inspection |
1. |
Check that the red light flickers when the door lock or unlock button is pressed on the transmitter. |
2. |
Remove the battery and check voltage if the red light doesn't flicker.
|
3. |
Insert the battery (A) into the tester (09954-2p100). |
4. |
Push the test button and If "0.00" is displayed on screen, it means that the battery voltage is 2V or less. |
5. |
If "L" is displayed on screen, it means that the battery is low power and it needs to replace. |
6. |
To prevent the discharge of electricity, turn the tester power off. |
7. |
If voltage is low power, replace the transmitter battery with
a new one. Then try to lock and unlock the doors with the transmitter
by pressing the lock or unlock button five or six times. |
8. |
If the doors lock and unlock, the transmitter is O.K, but if
the doors don't lock and unlock, register the transmitter code, then try
to lock and unlock the doors. |
9. |
If the doors lock and unlock, the transmitter is O.K, but if the doors don't lock and unlock, replace the transmitter.
|
Transmitter Code Registration (Using Code Saver) |
1. |
Open Door. |
2. |
Connect POWER (B+) and GND, signal line of Code Saver. |
3. |
If connection is normal, signal line is activated and RED LED turns ON. |
4. |
If SW of Code Saver turns ON, data via signal line will be transmitted. |
5. |
BCM enters into Code Save mode when it receives data from Code Saver and send Code Save Start signal via signal line. |
6. |
Code Saver turns Green LED ON when it receives Code Save Start signal. |
7. |
When you press Lock or Unlock button of transmitter, BCM will save Codes. |
8. |
If there are 2 transmitters for Code Saving, register by performing item 7). |
9. |
If SW of Code Saver turns OFF or is disconnected, Code Saving mode will be finished. |
Transmitter Code Registration (Using GDS) |
1. |
Connect the DLC cable of GDS to the data link connector (16 pins) in driver side crash pad lower panel, turn the power on GDS. |
2. |
Select the vehicle model and then do "CODE SAVING" |
3. |
After selecting "CODE SAVING" menu, button "ENTER" key, then the screen will be shown as below. |
4. |
After removing the ignition key from key cylinder, push
"ENTER" key to proceed to the next mode for code saving. Follow steps 1
to 4 and then code saving is completed. |
Hyundai Tucson (LM) 2010-2015 Owners Manual: Auto door lock/unlock features
All doors will be automatically locked when shifting the transaxle shift
lever out of P (Park) with the engine is running.
All doors will be automatically unlocked when shifting the transaxle shift
lever into P (Park) with the engine is running.
✽ NOTICE
An authorized HYUNDAI dealer ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Heated Steering wheel Repair procedures
Repair Procedures
1.
Measure a resistance of NTC and Heated pad.
A.
NTC resistance(Black / Yellow, Black) - 9.0 kx ~ kx (25°C)
B.
Heated pad resistance (Yellow, Black) - 1.4 ~ 1.8 x ± 10%
2.
Measure a temperature.
A.
The temperature of wheel surface grip must rise from -20°C t ...