Hyundai Tucson: Coupling Assembly / Pressure Sensor Repair procedures

Inspection
   
If you have trouble code related to the pressure sensor check pressure sensor according to the inspection process.
Pressure Sensor Inspection Procedure

Measure the resistance of pressure sensor
1.
Turn ignition switch OFF.
2.
Disconnect the pressure sensor connector.
3.
Measure resistance between sensor terminal and terminal.
4.
Check the measured resistance. (Refer to table)
Terminal
Resistance
PIN 2 – PIN 3
2.755 ~ 4.133 kx
PIN 1 – PIN 3
1.892 ~ 2.838 kx
PIN 1 – PIN 2
1.714 ~ 2.838 kx

Removal
1.
Remove the coupling assembly.
(Refer to Coupling Assembly - " Removal ")
2.
Remove the extension Cable (A).

3.
Remove the pressure sensor (A) with 24mm socket.
   
Keep going horizontal state to prevent leaks during remove the pressure sensor.

Tightening torque:
7.8 ~ 9.8 N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2 lb-ft)

Installation
   
Check the cleanliness of the pressure sensor before installation.
Check the pressure sensor O-ring (A).

1.
Install in the reverse order of removal.
Pressure Sensor Schematic Diagrams
Circuit Diagram ...

Driveshaft and axle
...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Description and Operation
Description Automatic Transaxle System relies on various measurement data to determine the current control status and extrapolate the necessary compensation values. These values are used to control the actuators and achieve the desired control output. If a problem with ...

Hyundai Tucson (LM) 2010-2015 Service Manual: ESC Control Unit Repair procedures
Removal 1. Turn the ignition switch OFF. 2. Disconnect the brake tubes from the HECU by unlocking the nuts counterclockwise with a spanner. Tightening torque : ABS : 12.7 ~ 16.7N.m(1.3 ~ 1.7kgf.m, 9.4 ~ 12.3lb-ft) ESC : 18.6 ~ 22.6N.m(1.9 ~ 2.3kgf.m, 13.7 ~ 16.6lb-ft) [LHD] [RHD] ...

© 2010-2024 www.htmanual.net