Hyundai Tucson: Hydraulic System / Fluid Repair procedures

Service Adjustment Procedure
Oil level Check
   
A check of ATF level is not normally required during scheduled services. If an oil leak is found, perform the oil level check procedure after repairs are completed.
   
When checking the oil level, be careful not to enter dust, foreign matters, etc. from fill hole.
1.
Remove the eyebolt (A).

Eyebolt tightening torque:
2.9 ~ 4.9 N.m (0.3 ~ 0.5 kgf.m, 2.2 ~ 3.6 lb-ft)

   
Always replace the gasket of the eyebolt use new one whenever loosening eyebolt.
2.
Add ATF SP-IV 700cc to the ATF injection hole.

3.
Start the engine.
(Don’t step on brake and accelerator simultaneously.)
4.
Confirm that the temperature of the A/T oil temperature sensor is 50 ~ 60°C(122 ~ 140°F) with the GDS.
5.
Shift the select lever slowly from “P” to “D”, then “D” to “P” and repeat one more at idle.
   
Keep on each speed position more than 2 sec.
6.
Lift the vehicle, then remove the oil level plug (A) from the valve body cover.

   
At this time, the vehicle must be at a level state.
7.
If the oil flows out of the overflow plug in thin steady stream, the oil level is correct.
Then finish the procedure and tighten the oil plug.
   
Oil level check (excess or shortage) method
Excess: Drain quantity exceed 900cc for tow minutes.{50 ~ 60°C (122 ~ 140°F)}
Shortage: No drain.
   
If there is no damage at the automatic transaxle and the oil cooler, the oil cooler hose, transaxle case, valve body tightening state are normal, ATF must drip out after performing above 1 to 7 procedures. After performing above 1 to 7 procedures, if the oil doesn’t drip out, inspect the automatic transaxle assembly.
   
Replace the gasket before reinstalling the oil level plug.

Oil level plug tightening torque:
Tightening up stopper

8.
Put down the vehicle with the lift and then tighten the eyebolt.
Replacement
   
ATF of 6 speed automatic transaxle doesn’t be replaced. But, if the vehicle is severe use or business use, replace ATF every 60,000 miles for severe usage.
Severe usage is defined as
Driving in rough road (Bumpy, Gravel, Snowy, Unpaved road, etc)
Driving in mountain road, ascent/descent
Repetition of short distance driving
More than 50% operation in heavy city traffic during hot weather above 32°C(89.6°F) .
Police, Taxi, Commercial type operation or trailer towing, etc
1.
Remove the drain plug (A) and reinstall the drain plug after draining ATF totally.


Drain plug tightening torque:
38.2 ~ 48.1 N.m (3.9 ~ 4.9 kgf.m, 28.2 ~ 35.4 lb-ft)

   
Replace the gasket before reinstalling the drain plug.
2.
Fill the oil about 5 liters.
3.
Check the oil level.
(Refer to Hydraulic System - "Fluid")
Fluid Components and Components Location
Components Location 1. Injection hole (eyebolt)2. Oil level plug3. Oil drain plug ...

Valve Body Description and Operation
Description The valve body is essential to automatic transaxle control and consists of various valves used to control the oil feed from the oil pump. Specifically, these valves ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Body Side Moldings Repair procedures
Replacement Roof Rack Replacement     • When prying with a flat-tipped screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damaged. • Put on gloves to protect your hands. • Take care not to scratch ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Control Shaft Assembly Repair procedures
Removal 1. Remove the following items; A. Air cleaner assembly and air duct. (Refer to "Intake and Exhaust system" in EM group.) B. Battery and battery tray. (Refer to "Charging system" in EE group.)     Set room side Shift lever to N position before remove the cont ...

© 2010-2024 www.htmanual.net