Hyundai Tucson: Automatic Transaxle Control System / Input Speed Sensor Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Input Speed Sensor Repair procedures

Inspection

Check signal waveform of Input & output speed sensor using the GDS.

Specification: Refer to "Signal Wave Form" section.

Removal

1.	Remove the valve body assembly. (Refer to Hydraulic System - "Valve Body")

2.	Disconnect the input & output speed sensor connector (A) from the main wiring.

Remove the input & output speed sensor (B) after removing the bolts(2ea).

Tightening torque :

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Installation

Install in the reverse order of removal.

•	Adding coolant. (Refer to Engine Mechanical System - "Coolant")

•	Adding Automatic Transaxle Fluid(ATF).

Input Speed Sensor Troubleshooting

Signal Waveform Fig 1) Input/Output speed sensor at low speed Fig 2) Input/Output speed sensor at high speed ...

Output Speed Sensor Description and Operation

Description The Output Speed Sensor is a vital unit that measures the rate of rotation of the transmission's turbine shaft and output shaft, and delivers the readings to the TCM. ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: SS-A Solenoid Valve(ON/OFF) Specifications
Specifications ON/OFF Solenoid Valve(SS-A, SS-B) x Control type : Normal low type Control pressure kpa (kgf/cmx, psi)490.33(5.0, 71.12) Internal resistance(x)10 ~ 11 ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Driver selectable steering mode (if equipped)
The Driver Selectable Steering Mode controls steering effort as driver's preference or road condition.You can select the desired steering mode by pressing the driver selectable steering mode button. The driver selectable steering mode stays in the last mode selected when turning the engine ...