Inspection |
1. |
Turn ignition switch OFF. |
2. |
Disconnect the solenoid valve connector. |
3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
4. |
Check that the resistance is within the specification. |
Removal |
Replacing an on/off solenoid valve (SS-A, SS-B) does not
require additional hydraulic pressure adjustment; however, the hydraulic
pressure will need to be adjusted after replacing the VFS solenoid
valve. If replacing the VFS solenoid valve; also replace the valve body
assembly.
(Refer to Hydraulic system - "Valve Body") |
Hyundai Tucson (LM) 2010-2015 Service Manual: Alternator Specifications
Specification
Alternator
ItemSpecificationRated voltage13.5V, 120ASpeed in use 1,000 ~ 18,000 rpmVoltage regulatorIC Regulator built-in typeRegulator Setting VoltageExternal mode Refer to below graphInternal mode14.55 ± 0.3V Temperature GradientExternal mode0 ± 3 mV / °CInternal mode-3.5 ± ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Passive Occupant Detection System (PODS) Repair procedures
Removal
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the front passenger seat assembly. (Refer to the Body group- Seat)
3.
Remove the seat cushion as an assembly. (Refer to the Body group- Seat)
Installation
1.
Inst ...