Removal |
1. |
Turm ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Disconnect the battery positive terminal and them remove the battery. |
3. |
Disconnect the ECM connector and the ECM and battery tray. |
4. |
Disconnect the brake fluid level switch connector (A), and remove the reservoir cap.
[LHD]
[RHD] |
5. |
Remove the brake fluid from the master cylinder reservoir with a syringe.
|
6. |
Disconnect the brake tube (A) from the master cylinder by loosening the tube flare nut.
[LHD]
[RHD] |
7. |
Remove the master cylinder (B) from the brake booster after loosening the mounting nuts (A).
[LHD
[RHD |
Installation |
1. |
Installation is the reverse of removal. |
2. |
After installation, bleed the brake system.
(Refer to Brake system bleeding) |
Hyundai Tucson (LM) 2010-2015 Owners Manual: Battery
Jump starting can be dangerous if done incorrectly. Follow the jump starting
procedure in this section to avoid serious injury or damage to your vehicle. If
in doubt about how to properly jump start your vehicle, we strongly recommend that
you have a service technician or towing service do it ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Flow Diagram
Power Flow Chart
P,NUD/BLR/B26/B35R/COD/COWCx
x Direction of Rotation
xLower & Reverse Brake (LR/B) Activation > Overdrive (O/D) Hub Lock > Mid & Rear P/C Lock
xInput Shaft Rotation > Rear Sun Gear Rotation > Rear
Inner Pinion Rotation (Reverse) > Rear Outer Pinion Rotation > R ...