Hyundai Tucson: Brake System / Brake Line Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Brake System / Brake System / Brake Line Repair procedures

Removal

1.	Disconnect the brake fiuid level switch connector, and remove the reservoir cap.

Remove the brake fluid from the master cylinder reservior with a syringe.

Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.

3.	Remove the wheel & tire.

4.	Remove the brake hose clip (A). [Front] [Rear]

Disconnect the brake tube by loosening the tube flare nut (B).

Tightening torque:

12.7 ~16.7 N.m (1.3 ~1.7 kgf.m, 9.4 ~12.3 lb-ft)

Disconnect the brake hose from the brake caliper by loosening the bolt (C).

Tightening torque:

24.5 ~29.4 N.m (2.5 ~3.0 kgf.m, 18.1 ~21.7 lb-ft)

[Front]

[Rear]

Inspection

1.	Check the brake tubes for cracks, crimps and corrosion.

2.	Check the brake hoses for cracks, damage and fluid leakage.

3.	Check the brake tube flare nuts for damage and fluid leakage.

4.	Check brake hose mounting bracket for crack or deformation.

Installation

Installation is the reverse of removal.

Use a new washer (A) whenever installing.

2.	After installation, bleed the brake system. (Refer to Brake system bleeding)

3.	Check the spilled brake oil.

Brake Line Components and Components Location

Components ...

Brake Pedal Components and Components Location

Components 1. Cowl bracket2. Brake pedal member assembly3. Stop lamp switch4. Return spring5. Brake pedal stopper6. Clevis pin7. Snap pin8. Brake pedal ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Special Service Tools
Special Service Tools Tool(Number and Name)IllustrationUseDeployment tool0957A-34100AAirbag deployment tool.Deployment adapter0957A-3Q100Use with deployment tool.(PAB, CAB, APT)Deployment adapter0957A-3F100Use with deployment tool.(SAB)Deployment adapter0957A-38500Use with deployment tool.(DAB, ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Oil Pan Repair procedures
Removal 1. Remove the under covers. (Refer to Engine and transaxle assembly) 2. Drain engine oil. 3. Remove the oil pan (A). (1) Unfasten the bolts. (2) Insert the blade of SST (09215-3C000) between the lower crankcase and the oil pan. Separate the applied sealer and remove the ...