Hyundai Tucson: Brake System / Brake Pedal Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Brake System / Brake System / Brake Pedal Repair procedures

Removal

1.	Remove the crash pad lower panel. (Refer to Body - "Crash Pad")

2.	Pull down steering column shaft after removing bolts and nuts.

3.	Disconnect the stop lamp switch connector (A).

Remove the brake pedal member mounting nuts (B).

Tightening torque:

16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.34 ~ 18.8 lb-ft)

5.	Remove the snap pin (A) and clevis pin (B).

Remove the brake pedal member assembly mounting nuts and then remove the brake pedal assembly.

Tightening torque:

16.7 ~ 25.5 N.m (1.7 ~2.6 kgf.m, 12.3 ~ 18.8 lb-ft)

Inspection

1.	Check the bushing for wear.

2.	Check the brake pedal for bending or twisting.

3.	Check the brake pedal return spring for damage.

Check the stop lamp switch.

(1)	Connect a circuit tester to the connector of stop lamp switch, and check whether or not there is continuity when the plunger of the stop lamp switch is pushed in and when it is released.

(2)	The stop lamp switch is in good condition if there is no continuity when plunger(A) is pushed.

Adjustment

Brake Pedal Height and Free Play

1.	Disconnect the stop lamp switch connector (A) and loosen the stop lamp switch lock nut.

Adjust the brake pedal height (A) as illustration below.

Pedal height (A) : 165 mm (6.50 in)

Full stroke : 135 mm (5.31 in)

Adjust the stop lamp switch clearance (B) and brake pedal free play.

Stop lamp clearance (B) : 1.5 ~ 2.0 mm (0.06 ~ 0.08 in)

Pedal free play : 3.0 ~ 8.0 mm (0.12 ~ 0.31 in)

4.	Connect the stop lamp switch connector.

Installation

Installation is the reverse of removal.

•	Before installing the pin, apply the grease to the clevis pin.

•	Use a new snap pin whenever installing.

2.	Adjust the brake pedal height and free play.

3.	Check the brake pedal operation.

Brake Pedal Components and Components Location

Components 1. Cowl bracket2. Brake pedal member assembly3. Stop lamp switch4. Return spring5. Brake pedal stopper6. Clevis pin7. Snap pin8. Brake pedal ...

Front Disc Brake Components and Components Location

Components 1. Guide rod bolt2. Bleed screw3. Caliper bracket 4. Caliper body5. Inner pad shim6. Brake pad7. Pad retainer ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Low tire pressure indicator
The low tire pressure indicator comes on for 3 seconds after the ignition switch is turned to the "ON" position. The low tire pressure indicator illuminates when one or more of your tires is significantly underinflated. The low tire pressure indicator will illuminate after it blinks for appr ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Timing Chain Components and Components Location
Components 1. Intake camshaft2. Exhaust camshaft3. Intake CVVT assembly4. Exhaust CVVT assembly5. Timing chain6. Timing chain tensioner arm7. Timing chain tensioner8. Timing chain guide9. Timing chain cover10. Service plug bolt & gasket11. Front oil seal12. Crankshaft damper pulley ...