Removal |
1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Remove the floor console. |
3. |
Disconnect the yaw rate & lateral & Longitudinal G sensor connector (A). |
4. |
Remove the mounting bolts (B).
|
5. |
Installation is the reverse of removal. |
6. |
Perform the Longitudinal Sensor Caliblation. |
Hyundai Tucson (LM) 2010-2015 Service Manual: Rear Driveshaft Repair procedures
Removal
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from rear hub.
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
Be careful not to damage to the ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Components and Components Location
Component Location
1. Slide motor2. Rear height motor3. Reclining motor4. Power seat switch5. Reclining switch6. Lumbar support switch7. Lumbar support motor
...