Hyundai Tucson: Audio / Audio Remote Control Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Body Electrical System / Audio / Audio Remote Control Repair procedures

Inspection

Check for resistance between No.6 and No.7 terminals in each switch position.

[Audio System]

Switch	Connector terminal	Resistance (±5%)
Volume down	6 - 7	6.81 kx
Volume up	6 - 7	4.61 kx
Mute	6 - 7	3.11 kx
Mode	6 - 7	2.11 kx
Seek down	6 - 7	1.11 kx
Seek up	6 - 7	430 x

Check for voltage between No.6 and No.7 terminal in each switch position.

[Audio System]

Switch	Connector terminal	Output voltage
Volume down	6 - 7	1.95 ± 0.16 V
Volume up	6 - 7	1.63 ± 0.16 V
Mute	6 - 7	1.31 ± 0.16 V
Mode	6 - 7	1.02 ± 0.16 V
Seek down	6 - 7	0.63 ± 0.16 V
Seek up	6 - 7	0.28 ± 0.16 V

Removal

1.	Remove the driver airbag module. (Refer to the RT group - "Airbag module")

2.	Remove the steering wheel screws from the back cover.

3.	Disconnect the audio remote control switch connector (A).

Remove the audio remote control switch (A).

Be careful not to damage the hook when removing the switch.

Installation

1.	Install the audio remote control switch on the steering wheel.

2.	Install the steering wheel.

Reconnect the audio remote control switch connector and airbag connectors.

Make sure that the switch connector is plugged in properly.

Install the driver airbag module.

Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Make sure horn button works.

Audio Remote Control Schematic Diagrams

Circuit Diagram ...

AUX(Auxiliary) Jack Schematic Diagrams

Circuit Diagram ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Seat belt warning light
Seat belt warning light (for driver’s seat) The driver’s seat belt warning light and chime will come on according to the following table when the ignition switch is in the ON position. *1 : The Warning Pattern repeats 11 times with an interval of 24 seconds. If the driver's seat belt i ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Battery Repair procedures
Adjustment Battery charging In general, vehicle battery charging system has three forms. 1. Constant current charge: The battery voltage gradually rises by charging with setting a constant current. If charging current and time are not managed correctly, the battery is over-charged, the ...