Hyundai Tucson: Seat Electrical / Power Seat Motor Repair procedures

Inspection
Power Seat Motor
1.
Remove the front seat.
(Refer to BD group - "Front seat")
2.
Disconnect the connectors for each motor.

3.
With the battery connected directly to the motor terminals, check if the motors run smoothly.

4.
Reverse the connections and check that the motor turns in reverse.
5.
If there is an abnormality, replace the motors.
Components and Components Location
Component Location 1. Slide motor2. Rear height motor3. Reclining motor4. Power seat switch5. Reclining switch6. Lumbar support switch7. Lumbar support motor ...

Power Seat Control Switch Repair procedures
Inspection 1. With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat switch. Remo ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Specifications
Specifications Tightening Torques ItemsN.mKgf.mlb-ftTransfer assembly mounting bolts60.8~65.76.2~6.744.8~48.54WD ECM mounting nuts9.8~11.81.0~1.27.2~8.7Coupling assembly mounting bolts56.9~64.75.8~6.642.0~47.7Propeller shaft mounting bolts49.0~68.65.0~7.036.2~50.6Transfer oil drain plug39.2~ ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Oil level sensor Repair procedures
Removal and Installation [For Europe] When the oil sensor signal fault occurs, refer to the DTC guide. 1. Drain the engine oil. 2. Remove the oil level sensor (A) after disconnecting the oil level sensor connector. Tightening torque: 8.8 ~ 9.8N.m (0.9 ~ 1.0kgf.m, 6.5 ~ 7.2lb-ft) ...

© 2010-2024 www.htmanual.net