Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the roof trim.
(Refer to the BD group - "Roof trim") |
3. |
Remove the panoramaroof motor (A) after disconnecting the connector (10 Pin). |
4. |
Ground the terminals as below table, and check that the panoramaroof unit operates as below table. |
5. |
Make these input tests at the motor connector of panoramaroof harness
if any test indicates a problem, find and correct the cause, then recheck the system.
If all the input tests prove OK, the sunroof motor must be faulty; replace it.
|
6. |
Make these input tests at the console connector of panoramaroof harness
if any test indicates a problem, find and correct the cause, then recheck the system.
If all the input tests prove OK, the sunroof motor must be faulty; replace it.
|
1. |
Turn the ignition key to the ON position and then close the panoramaroof completely. |
2. |
Release the panoramaroof control lever. |
3. |
Press and hold the CLOSE button for more than 10 seconds until the sunroof has moved slightly. |
4. |
Release the panoramaroof control lever. |
5. |
Press and hold the CLOSE button once again until the sunroof do as follows;
|
6. |
Reset procedure of panorama system is finished. |
1. |
The Panoramaroof ECU detects the Run- time of motor |
2. |
Motor can be operated continuously for the 1st Run-time(120 ± 10sec.). |
3. |
Motor which is operated continuously stops operating after the 1st Run-time(120 ± 10sec.). |
4. |
And then Motor is not operated for the 1st Cool-time(18 ± 2sec.). |
5. |
Motor is operated for the 2nd Run-time(10 ± 2sec.) at the continued motor operation after 1st Cool-time(18 ± 2sec.) |
6. |
Motor which is operated continuously stops operating after the 2nd Run-time(10 ± 2sec.) |
7. |
Motor is not operated for the 2nd Cool-time(18 ± 2sec.). |
8. |
Motor repeats the 2nd Run-time and 2nd Cool-time at the continued motor operation.
T1 : 120 ± 10 sec., T2 : 18 ± 2 sec.,
T3 : 10 ± 2 sec., T4 : 18 ± 2 sec. |
Hyundai Tucson (LM) 2010-2015 Service Manual: Ignition Coil Repair procedures
Removal
1.
Disconnect the battery nagative terminal.
2.
Remove the engine cover.
3.
Disconnect the ignition coil connectors (A).
•
When removing the ignition coil connector, pull the lock pin (A) and push the clip (B).
4.
Remove the ignition coil (A). ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Front Fog Lamps Repair procedures
Inspection
Front Fog Lamp Switch
1.
With the fog lamp switch in each position, make sure that
continuity exists between the terminals below. If continuity is not as
specified, replace the multifunction switch.
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the f ...