Hyundai Tucson: Lighting System / Overhead Console Lamp Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Body Electrical System / Lighting System / Overhead Console Lamp Repair procedures

Inspection

Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch.

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the overhead console lamp assembly. (Refer to the BD group - "Roof trim")

3.	Remove the overhead console bulb (B) after disconnecting the panoramaroof switch connector and lamp connector (A).

4.	When replacing the bulb only, release the lens (C) cover from the roof without removing the overhead console lamp assembly.

Installation

1.	Install the bulbs and connect the connectors.

2.	Install the overhead console lamp assembly.

Room Lamp Repair procedures

Inspection 1. Remove the room lamp assembly connector (A) then check for continuity between terminals. Removal 1. Disconnect the negative (-) battery terminal. 2. Detach the lamp lens (A) ...

Hazard Lamp Switch Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the hazard lamp switch assembly. (Refer to the BE group - "Audio head unit") 3. Disconnect the hazard lamp switch conne ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Repair procedures
Compression Pressure Inspection If the there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure. 1. Warm up and stop engine. Allow the engine to warm up to normal operating temperature. 2. Disconnect the injector exten ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Components and Components Location
Component Location Engine Room 1. Condenser2. Receiver-drier 3. Compressor 4. Expansion Valve5. Service port (High)6. Service port (Low)7. A/C Pressure Transducer Interior ...