Inspection |
1. |
With the fog lamp switch in each position, make sure that
continuity exists between the terminals below. If continuity is not as
specified, replace the multifunction switch. |
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front bumper.
(Refer to the BD group - "Front bumper") |
3. |
Remove the front fog lamp (A) by turning in the counterclockwise direction after disconnecting the connector. |
4. |
Remove the front fog lamp (A) after loosening the screws. |
Installation |
1. |
Install the front fog lamp bulb. |
2. |
Connect the front fog lamp connector. |
3. |
Install the front bumper. |
Hyundai Tucson (LM) 2010-2015 Service Manual: Repair procedures
On-vehicle Inspection
Inspect ignition coil assembly and Perform spark test
1.
Check for DTCs.
•
If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC. (Refer to DTC guide)
2.
Check if sparks occur.
(1)
Remove the engi ...
Hyundai Tucson (LM) 2010-2015 Owners Manual: Light bulbs
Consult an authorized HYUNDAI dealer to replace most vehicle light bulbs. It
is difficult to replace vehicle light bulbs because other parts of the vehicle must
be removed before you can get to the bulb. This is especially true for removing
the headlight assembly to get to the bulb(s).
Removi ...