Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Loose the screws (2EA) holding the rear combination lamp then
disconnect the connector (A) then remove the outside rear combination
lamp (B). |
3. |
Turn the socket counterclockwise to remove the tail/stop lamp bulb (A) and turn signal lamp bulb (B). |
4. |
Loosen the nuts (A) after removing the liftgate lamp cover. |
5. |
Remove the liftgate lamp (B) after disconnecting the connector (A). |
6. |
Turn the socket counterclockwise to remove the back up lamp bulb (A) and tail lamp bulb (B). |
7. |
If the bulbs should be only replaced without removing lamp
assembly, replace the back up lamp bulb (A) and tail lamp bulb (B) after
removing the liftgate lamp cover inside trunk. |
Installation |
1. |
Install the liftgate combination lamp assembly after assembling the bulb. |
2. |
Install the lamp cover to the liftgate after connecting the lamp connector. |
3. |
Install the rear combination lamp assembly after assembling the bulbs and connecting the lamp connector. |
Hyundai Tucson (LM) 2010-2015 Service Manual: In car sensor Repair procedures
Inspection
1.
Ignition "ON"
2.
Blow air with changing temperature to the in car sensor air inlet. Measure sensor resistance between 1 and 2 terminals.
1. Sensor Ground2. Incar Sensor Signal
Specification
Temperature [°C(°F)] Resistance between terminals 1and 2 (kx)-20(-4)290.21-10(1 ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Under Body Body Repair
Projected Dimensions [2WD]
Actual- Measurement Dimensions [2WD]
Projected Dimensions [4WD]
Actual- Measurement Dimensions [4WD]
...