Hyundai Tucson: Immobilizer System / Immobilizer Control Unit Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Body Electrical System / Immobilizer System / Immobilizer Control Unit Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the crash pad lower panel. (Refer to the BD group - "Crash pad")

3.	Remove the steering column assembly. (Refer to the ST group - "steering column & shaft")

4.	Disconnect the 5P connector of the SMARTRA unit and then remove the SMARTRA unit (A) after loosening a bolt. [LHD] [RHD]

Installation

1.	Install the immobilizer control unit after connecting the unit connector.

2.	Install the steering column assembly.

3.	Install the crash pad lower panel.

Repair procedures

Replacement Problems And Replacement Parts: ProblemPart setScan tool requiredxAll keys have been lostBlank key (4)YESAntenna coil unit does not workAntenna coil unitNOECM does not workPCM(ECM)YESI ...

Antenna Coil Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper and lower shrouds (A). [LHD] [RHD] Take care not to damage and scratch the ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Spark Plug Repair procedures
Inspection [On vehicle inspection] 1. Accelerate the engine to about 3,000 rpm 3 times or more. 2. Remove the spark plug. 3. Check the spark plug visually. If the electrode is dry, the spark plug is normal. If the electrode is wet, check the damage and electrode gap as below. [ ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Corrosion protection
Protecting your vehicle from corrosion By using the most advanced design and construction practices to combat corrosion, HYUNDAI produces cars of the highest quality.However, this is only part of the job. To achieve the long-term corrosion resistance your vehicle can deliver, the owner's coop ...