Hyundai Tucson: Rear Parking Assist System / Buzzer Repair procedures

Inspection
Test the buzzer by connecting battery voltage to the 1 terminal and ground the 2 terminal.
The buzzer should make a sound. If the buzzer fails to make a sound, replace it.
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
3.
Remove the buzzer (A) after loosening the bolt and disconnecting the 2P connector.
[LHD]

[RHD]

Installation
1.
Connect the connector, and then install the buzzer.
2.
Install the crash pad lower panel.
Ultrasonic Sensor Repair procedures
Removal 1. Remove the rear bumper. (Refer to the BD group - "Rear bumper") 2. Disconnect the sensor connector (A) inside the rear bumper. 3. Pull out the sensor (A) by opening the sensor ...

Button Engine Start System
...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: General Information
General Troubleshooting Information Before Troubleshooting 1. Check applicable fuses in the appropriate fuse/relay box. 2. Using the battery checker (MCR-570 KIT), check the battery for damage, state of charge, and clean and tight connections. (Refer to the EE group - "Battery") &nbs ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Rear Bumper Components and Components Location
Components 1. Rear bumper assembly2. Rear bumper mounting bracket ...

© 2010-2024 www.htmanual.net