Hyundai Tucson: Ignition Switch Assembly / Repair procedures

Inspection
1.
Disconnect the ignition switch connector (B) and key warning switch connector (A) from under the steering column.

2.
Check for continuity between the terminals.
3.
If continuity is not specified, replace the switch.

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds.
(Refer to the ST group - "Steering column")
3.
Remove the ignition switch (A) after disconnecting the 6P connector (B).

4.
Remove the key warning and immobilizer connector (A).

5.
Remove the key illumination lens (A).

6.
If it is necessary to remove the key lock cylinder (A), remove the key lock cylinder after pushing lock pin (B) with key ACC.

Installation
1.
Install the key lock cylinder.
2.
Install the illumination bulb, lens and cover.
3.
Install the key warning and immobilizer connector.
4.
Install the ignition switch.
5.
Install the steering column shrouds and crash pad lower panel.
Ignition Switch Assembly
...

Back View Camera System
...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Radiator Components and Components Location
Components 1. Cooling fan & shroud2. Radiator3. Radiator upper hose4. Radiator lower hose5. Mounting insulator6. Reservoir tank7. Fan motor ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Special Service Tools
Special Service Tools Tool(Number and Name)IllustrationUse09581-11000Piston expanderSpreading the front disc brake piston. ...

© 2010-2024 www.htmanual.net