Hyundai Tucson: General Information / Specifications

Specification
Air Conditioner
Item
Specification
Compressor
Type
DVE16
Oil type & Capacity
PAG OIL 120±10cc (4.2±0.35 OZ.)
Pulley type
6PK-TYPE
Displacement
160cc/rev
Condenser
Heat rejection
14,000±5% kcal/hr
A/C Pressure transducer
The method to measure the pressure
Voltage= 0.00878835 * Pressure (psig) + 0.5
Expansion valve
Type
Block type
Refrigerant
Type
R-134a
Capacity [oz.(g)]
550±25 (19.4±0.88)

Blower Unit
Item
Specification
Fresh and recirculation
Operating method
Actuator
Blower
Type
Sirocco
Speed step
Auto + 8 speed (Automatic), 1~4speed (Manual)
Speed control
Power mosfet (Auto)
Air filter
Type
Particle filter

Heater And Evaporator Unit
Item
Specification
Heater
Type
Pin & Tube type
Heating capacity
4,550 - 5% kcal/hr
Mode operating method
Actuator
Temperature operating method
Actuator
Evaporator
Temperature control type
Evaporator temperature sensor
A/C ON/OFF [°C(°F)]
ON : 1.5 ± 0.3 (34.7 ± 32.5)
OFF: -0.5 ± 0.3 (31.1 ± 32.5)

Tightening Torque
Part tightened
N.m
Kgf.m
lb-ft
Condenser - Discharge hose
4.9~5.9
0.5~0.6
3.6~4.3
Condenser - Liquid tube
Compressor - Discharge hose
4.9~5.9
0.5~0.6
3.6~4.3
Compressor - Suction hose
Expansion valve - Evaporator
11.8~14.7
1.2~1.5
8.7~10.9

General Information
...

Troubleshooting
Troubleshooting Problem Symptoms Table Before replacing or repairing air conditioning components, first determine if the malfunction is due to the refrigerant charge, air flow or compressor. ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Display Settings
Adjusting the Brightness Press the  key  Select [Display]  Select [Brightness] Use the ,  buttons to adjust the screen brightness or set the Brightness on Automatic, Daylight, or Night mode. Press the  button to reset. 1) Automatic : Adjusts the brightness a ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Crankshaft Position Sensor (CKPS) Troubleshooting
Signal waveform This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using these signals. Generally CkPS signal is used to detect the piston's position and CMPS signal is use ...

© 2010-2024 www.htmanual.net