Troubleshooting |
Problem Symptoms Table |
Symptom | Suspect Area |
No blower operation | 1. Blower fuse |
2. Blower relay | |
3. Blower motor | |
4. Power mosfet | |
5. Blower speed control switch | |
6. Wire harness | |
No air temperature control | 1. Engine coolant capacity |
2. Heater control assembly | |
No compressor operation | 1. Refrigerant capacity |
2. A/C Fuse | |
3. Magnetic clutch | |
4. Compressor | |
5. A/C pressure transducer | |
6. A/C switch | |
7. Evaporator temperature sensor | |
8. Wire harness | |
No cool comes out | 1. Refrigerant capacity |
2. Refrigerant pressure | |
3. Drive belt. | |
4. Magnetic clutch. | |
5. Compressor | |
6. A/C pressure transducer | |
7. Evaporator temperature sensor. | |
8. A/C switch. | |
9. Heater control assembly | |
10. Wire harness | |
Insufficient cooling | 1. Refrigerant capacity |
2. Drive belt | |
3. Magnetic clutch | |
4. Compressor | |
5. Condenser | |
6. Expansion valve | |
7. Evaporator | |
8. Refrigerant lines | |
9. A/C pressure transducer | |
10. Heater control assembly | |
No engine idle-up when A/C switch ON | 1. Engine ECM |
2. Wire harness | |
No air inlet control | 1. Heater control assembly |
No mode control | 1. Heater control assembly |
2. Mode actuator | |
No cooling fan operation | 1. Cooling fan fuse |
2. Fan motor | |
3. Engine ECM | |
4. Wire harness |
Hyundai Tucson (LM) 2010-2015 Owners Manual: Trailer towing equipment
Hitches
It's important to have the correct hitch equipment. Crosswinds, large trucks
going by, and rough roads are a few reasons why you’ll need the right hitch. Here
are some rules to follow:
Do you have to make any holes in the body of your vehicle when you install
a trailer hitch? I ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Driver Airbag (DAB) Module and Clock Spring Repair procedures
Removal
1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Remove the airbag module mounting bolts (2EA).
3.
Remove the wiring fixing clip (C) and disconnect the horn connector (A).
4.
Release the connector locking pin, then discon ...