Inspection |
1. |
Check the condenser fins for clogging and damage. If clogged,
clean them with water, and blow them with compressed air. If bent,
gently bend them using a screwdriver or pliers. |
2. |
Check the condenser connections for leakage, and repair or replace it, if required.
|
Replacement |
1. |
Recover the refrigerant with a recovery/ recycling/ charging station . |
2. |
Disconnect the negative (-) battery terminal. |
3. |
Remove the front bumper.
(Refer to BD group - Front Bumper) |
4. |
Remove the discharge line and liquid line (A) from the condenser and then disconnect the condenser side cover (B). |
5. |
Remove the condenser (A) from radiator. |
6. |
Install in the reverse order of removal, and note these items :
|
Hyundai Tucson (LM) 2010-2015 Service Manual: Side Impact Sensor (SIS) Description and Operation
Description
Side Impact Sensor (SIS) system consists of two P-SIS which
are installed at each center of the front door module (LH and RH) and
two SIS which are installed at each center pillar nearby (LH and RH).
Side Pressure Sensor is also called P-SIS because that detects pressure due to c ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Cylinder Block Repair procedures
Disassembly
Engine removal is required for this procedure.
•
Use fender covers to avoid damaging painted surfaces.
•
To avoid damaging the cylinder head, wait until the engine
coolant temperature drops below normal temperature before removing it.
•
...