Hyundai Tucson: Air Conditioning System / Receiver-Drier Repair procedures

Replacement
1.
Remove the condenser, and then remove the bottom cap (B) with L wrench (A) from the condenser.

Tightening torque :
20 ~ 25 N.m (2.0 ~ 2.5 kgf.m, 14.5 ~ 18.2 lb-ft)

2.
Remove the desiccant (A) from condenser using a long nose plier. Check for crumbled desiccant and clogged bottom cap filter.

3.
Apply air conditioning compressor oil along the O-rings and threads of the new bottom cap.
4.
Insert the new desiccant into the receiver drier tank. The desiccant must be sealed in vacuum before it is exposed to air for use.
5.
Install the new bottom cap to the condenser.
   
-
Always replace the desiccant and bottom cap at the same time.
-
Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the right O-rings for R-134a to avoid leakage.
-
Be careful not to damage the radiator and condenser fins when installing the condenser.
-
Be sure to install the lower mount cushions of condenser securely into the holes.
-
Charge the system, and test its performance.
Condenser Repair procedures
Inspection 1. Check the condenser fins for clogging and damage. If clogged, clean them with water, and blow them with compressed air. If bent, gently bend them using a screwdriver or pliers. ...

A/C Pressure Transducer Components and Components Location
Component Location ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Overhead Console Lamp Repair procedures
Inspection Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch.Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the overhead console lamp assembly. (Refer to the B ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Rear seat headrest
The rear seats are equipped with headrests in all the seating positions for the passenger’s safety and comfort. Adjusting the height up and down To raise the headrest: 1. Pull it up to the desired position (1). To lower the headrest: 1. Push and hold the release button (2) on the he ...

© 2010-2024 www.htmanual.net