Inspection |
1. |
Press the OFF switch more then 4 times within 2 seconds while pressing the MODE switch.
* Diagnostic procedure refer to DTC code.
|
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the extension cover (A). |
3. |
Disconnect the damper (A) from the glove box (B). |
4. |
Remove the glove box lift (A). |
5. |
Disconnect the pine (A), then remove the glove box (B). |
6. |
Remove the crash pad passenger panel (A). |
7. |
Remove the glove box housing (A). |
8. |
Remove the shower duct (A). |
9. |
Loosen the screws and then remove the cluster ionizer (A). |
10. |
Install in the reverse order of removal. |
Hyundai Tucson (LM) 2010-2015 Service Manual: Repair procedures
Compression Pressure Inspection
If the there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure.
1.
Warm up and stop engine.
Allow the engine to warm up to normal operating temperature.
2.
Disconnect the injector exten ...
Hyundai Tucson (LM) 2010-2015 Service Manual: External Amplifier Components and Components Location
Components
Connector Pin Information
No.Connector A (26 pin)Connector B (16 pin)Connector C (12 pin)1Battery +Right surround speaker +Rear right door +2Battery +Left surround speaker +Rear left door speaker +3Battery +-Front right tweeter speaker +4--Front left tweeter speaker +5CAN +-Fron ...