Hyundai Tucson: Exterior care / Underbody maintenance

Corrosive materials used for ice and snow removal and dust control may collect on the underbody. If these materials are not removed, accelerated rusting can occur on underbody parts such as the fuel lines, frame, floor pan and exhaust system, even though they have been treated with rust protection.

Thoroughly flush the vehicle underbody and wheel openings with lukewarm or cold water once a month, after off-road driving and at the end of each winter. Pay special attention to these areas because it is difficult to see all the mud and dirt. It will do more harm than good to wet down the road grime without removing it.

The lower edges of doors, rocker panels, and frame members have drain holes that should not be allowed to clog with dirt; trapped water in these areas can cause rusting.

WARNING

After washing the vehicle, test the brakes while driving slowly to see if they have been affected by water. If braking performance is impaired, dry the brakes by applying them lightly while maintaining a slow forward speed.

Bright-metal maintenance
To remove road tar and insects, use a tar remover, not a scraper or other sharp object. To protect the surfaces of brightmetal parts from corrosion, apply a coating of wax or chrome preserv ...

Aluminum and chrome wheel maintenance
The aluminum and chrome wheels are coated with a clear protective finish. CAUTION Do not use abrasive cleaner, polishing compound, solvent, or wire brushes on aluminum or chrome wheels. Clea ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: High beam operation
To turn on the high beam headlights, push the lever away from you. Pull it back for low beams. The high beam indicator will light when the headlight high beams are switched on. WARNING Do not use the high beams when there are other vehicles approaching you. Using high beam could obstruc ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Steering Gear box Repair procedures
Replacement 1. Remove the front wheel & tire. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     Be careful not to damage to the hub bolts when removing the front wheel & tire. 2. Disconnect the stabilizer link (B) with the front ...

© 2010-2024 www.htmanual.net