Hyundai Tucson: Maintenance / Emission control system

Hyundai Tucson (LM) 2010-2015 Owners Manual / Maintenance / Emission control system

The emission control system of your vehicle is covered by a written limited warranty. Please see the warranty information contained in the Owner’s Handbook & Warranty Information booklet in your vehicle.

Your vehicle is equipped with an emission control system to meet all applicable emission regulations. There are three emission control systems, as follows.

(1) Crankcase emission control system

(2) Evaporative emission control system

(3) Exhaust emission control system

In order to assure the proper function of the emission control systems, it is recommended that you have your vehicle inspected and maintained by an authorized HYUNDAI dealer in accordance with the maintenance schedule in this manual.

CAUTION

For the Inspection and Maintenance Test (With Electronic Stability Control (ESC) system)

To prevent the vehicle from misfiring during dynamometer testing, turn the Electronic Stability Control (ESC) system off by pressing the ESC switch (ESC OFF light illuminated).
After dynamometer testing is completed, turn the ESC system back on by pressing the ESC switch again.

Interior care

Interior general precautions Prevent caustic solutions such as perfume and cosmetic oil, from contacting the interior parts because they may cause damage or discoloration. If they do contact the ...

1. Crankcase emission control system

The positive crankcase ventilation system is employed to prevent air pollution caused by blow-by gases being emitted from the crankcase. This system supplies fresh filtered air to the crankcase thr ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Instrument Cluster Schematic Diagrams
Circuit Diagram (1) Circuit Diagram (2) Massage Flow Diagram ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Instrument Cluster Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the cluster fascia panel (A). [LHD] [RHD] 3. Remove the cluster fascia lower panel (A). [LHD] [RHD] 4. Remove the cluster fascia (A) from the housing after loosening 4 screws. [LHD] [RHD] 5. Disconnect the ...