Hyundai Tucson: Cooling System / Water pump Components and Components Location
| Components |
| 1. Water pump pulley 2. Water pump 3. Water pump gasket 4. Water inlet fitting | 5. Thermostat 6. Water temperature control assembly 7. Engine coolant temperature sensor 8. Bypass hose | 9. Heater pipe & hose assembly 10. Throttle body coolant hose |
Radiator Repair procedures
Inspection
Radiator Cap Testing
1.
Remove the radiator cap, wet its seal with engine coolant, and then install it on a pressure tester.
2.
Apply a pressure of 93.16~122.58 kPa (0.95~1.25 kgf/ ...
Water pump Repair procedures
Removal and Installation
1.
Loosen the drain plug, and then drain the engine coolant. Remove the radiator cap to help drain the coolant faster.
2.
Remove the drive belt.
(Refer to Timing sys ...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Knock Sensor (KS) Description and Operation
Description
Knocking is a phenomenon characterized by undesirable
vibration and noise and can cause engine damage. Knock Sensor (KS) is
installed on the cylinder block and senses engine knocking.
When knocking occurs, the vibration from the cylinder block
is applied as pressure to the piez ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Transaxle Oil Temperature Sensor Description and Operation
Description
Transmission Oil Temperature Sensor monitors the automatic
transmission fluid's temperature and conveys the readings to TCM. It is
an NTC (Negative Thermal Coefficient) sensor whose resistance has an
inversely proportional relationship with the temperature level. Data
produced ...
