Removal and Installation |
1. |
Loosen the drain plug, and then drain the engine coolant. Remove the radiator cap to help drain the coolant faster. |
2. |
Remove the drive belt.
(Refer to Timing system in this group) |
3. |
Remove the water pump pulley (A).
|
4. |
Remove the water pump assembly (A) with the gasket (B).
|
5. |
Installation is reverse order of removal
|
6. |
Fill the engine coolant. |
7. |
Start the engine and check for leaks. |
8. |
Recheck the coolant level. |
Inspection |
1. |
Check each part for cracks, damage or wear, and replace the coolant pump assembly if necessary. |
2. |
Check the bearing for damage, abnormal noise and sluggish rotation, and replace the coolant pump assembly if necessary. |
3. |
Check for coolant leakage. If coolant leaks from hole, the seal is defective. Replace the coolant pump assembly.
|
Hyundai Tucson (LM) 2010-2015 Owners Manual: Seat belt use and children
Infant and small children
All 50 states have child restraint laws which require children to travel in approved
child restraint devices, including booster seats. The age at which seat belts can
be used instead of child restraints differs among states, so you should be aware
of the specific req ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Rear Upper Arm Repair procedures
Replacement
1.
Remove the rear wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
Be careful not to damage to the hub bolts when removing the rear wheel & tire.
2.
Loosen the bolt & nut and then remove the rear upp ...