Hyundai Tucson: Intake And Exhaust System / Exhaust Manifold Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Mechanical System / Intake And Exhaust System / Exhaust Manifold Repair procedures

Removal and Installation

1.	Remove the engine cover.

Disconnect the battery negative terminal.

Tightening torque:

3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 3.0 ~ 4.4 lb-ft)

3.	Disconnect the front oxygen sensor connector (A) and then remove it from the bracket.

Remove the front muffler (A).

Tightening torque:

39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft)

Remove the exhaust manifold heat protector (A).

Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

6.	Remove the driveshaft heat protector (A).

Remove the exhaust manifold stay (A).

Tightening torque:

39.2 ~ 49.0 N.m (4.0 ~ 5.0 kgf.m, 28.9 ~ 36.2 lb-ft)

Remove the exhaust manifold (A) with the gasket (B).

Tightening torque:

29.4 ~ 34.3 N.m (3.0 ~ 3.5 kgf.m, 21.7 ~ 25.3 lb-ft)

When installing the exhaust manifold, tighten the nuts with pre-torque first, and then tighten the nuts with specified torque in the sequence shown.

Installation is reverse order of removal.

When installing, replace with a new gasket.

Exhaust Manifold Components and Components Location

Components 1. Heat protector2. Exhaust manifold gasket3. Exhaust manifold4. Exhaust manifold stay ...

Muffler Components and Components Location

Components 1. Front muffler2. Catalytic converter & center muffler assembly3. Main muffler4. Gasket5. Hanger ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Special Service Tools
Special Tools Tool (Number and name)IllustrationUse09880-4F000Hog ring clip installerHog ring clip Installation09816-2S100Fixed glass fixture Installation the fixed glass ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Reprogramming a single HomeLink® button
To program a new device to a previously trained HomeLink® button, follow these steps: 1. Press and hold the desired HomeLink® button. Do NOT release until step 4 has been completed. 2. When the indicator light begins to flash slowly (after 20 seconds), position the handheld transmitter 1 t ...