Hyundai Tucson: Ignition System / Ignition Coil Repair procedures

Removal
1.
Disconnect the battery nagative terminal.
2.
Remove the engine cover.
3.
Disconnect the ignition coil connectors (A).

   
When removing the ignition coil connector, pull the lock pin (A) and push the clip (B).

4.
Remove the ignition coil (A).

Installation
1.
Install in the reverse order of removal.

Ignition coil installation bolts: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 Ib-ft)

Inspection
1.
Measure the primary coil resistance between terminals (+) and (-).


Standard value: 0.75x ± 15%

Ignition Coil Schematic Diagrams
Circuit Diagram [M/T] [A/T] ...

Spark Plug Description and Operation
Description A spark plug is a device for delivering electric current from an ignition system to the combustion chamber of a spark-ignition engine to ignite the compressed fuel/air mixture there ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Dynamic Damper Components and Components Location
Components 1. BJ assembly2. BJ circlip3. BJ boot band4. BJ boot5. Dynamic damper band6. Dynamic damper7. Shaft8. TJ boot band9. TJ boot10. Spider assembly11. Retainer ring12. TJ housing13. Housing circlip ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Oil Cooler Repair procedures
Inspection Radiator Cap Testing 1. Remove the radiator cap, wet its seal with engine coolant, and then install it on a pressure tester. 2. Apply a pressure of 93.16 ~ 122.58 kPa (0.95 ~ 1.25 kgf/cmx, 13.51 ~ 17.78 psi). 3. Check for a drop in pressure. 4. If the pressure drops, re ...

© 2010-2024 www.htmanual.net