Hyundai Tucson: Charging System / Alternator Schematic Diagrams

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Electrical System / Charging System / Alternator Schematic Diagrams

Circuit Diagram

•	COM signal - When controlling the voltage generated, the ECM sends the target voltage data to the alternator via a PWM signal.(High voltage: 4V or higher, low voltage: 2V or lower)

•

FR signal - The transistor activation signal inside the alternator monitors the voltage generated by the alternator to control the excitation current before it sends the FR signal to the ECM. (At certain RPM/electric loads, the FR duty can remain static. However, more often, the RPM, electric load, target voltage, etc. are always changing in the vehicle, so the FR must also change constantly)

•	L signal - Turns on the battery warning lamp on the dashboard when the battery charging system malfunctions. (Conditions for turning on the lamp - overcharge, over discharge, a field coil blown inside the alternator)

•	B+ terminal - The output voltage from the generator travels to the battery via the B+ terminal.

Alternator Components and Components Location

Components 1. OAD (Overrunning Alternator Decoupler) pulley2. Front housing3. Front bearing4. Stator5. Rotor 6. Rear bearing 7. Rear housing 8. Rectifier assembly 9. Regulator assembly 10. Rear c ...

Alternator Repair procedures

Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the drive belt. (Refer to Engine Mechanical System - "Drive Belt") 3. Disconnect the alternat ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Water pump Troubleshooting
Troubleshooting Water Pump SymptomsPossible CausesRemedyCoolant leakage • From the bleed hole of the water pump Visually check • Check leaks after about ten-minute warming up. • If coolant still leaks, replace a water pump. • If leakage stops, reuse the water pump (D ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Battery
Jump starting can be dangerous if done incorrectly. Follow the jump starting procedure in this section to avoid serious injury or damage to your vehicle. If in doubt about how to properly jump start your vehicle, we strongly recommend that you have a service technician or towing service do it ...