Hyundai Tucson: Evaporative Emission Control System / Fuel Filler Cap Description and Operation

Hyundai Tucson (LM) 2010-2015 Service Manual / Emission Control System / Evaporative Emission Control System / Fuel Filler Cap Description and Operation

Description

A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which seals the fuel filler. After the gasket on the fuel filler cap and the filler neck flange contact each other, the ratchet produces a loud clicking noise indicating the seal has been set.

1. Cover
2. Torsion spring
3. Retainer
4. Gasket seal

5. Spring
6. Plate seal
7. Vacuum valve
8. Spring

Canister Repair procedures

Removal 1. Remove the fuel tank. (Refer to "Fuel tank" in FL group.) 2. Disconnect the vapor tube quick-connector (A,B) and the ventilation hose (C). 3. Remove the canister in the direct ...

Fuel Tank Air Filter Repair procedures

Replacement 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Lift the vehicle with a jack. 3. Disconnect the canister close valve connector (A). 4. Dis ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Specifications
Specifications SPAS unitPowerIGN 1Operating voltage9V ~ 16VSPAS sensor (Front/Rear)Number of sensors4EA (Front), 4EA (Rear)Operation voltage 9V ~ 16VSupply current 0.5mA ~ 5mAOperation frequency 51.2 KhzDetecting range 2mDetection angle(horizontal) 75°Detection angle(V ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Recommended SAE viscosity number
CAUTION Always be sure to clean the area around any filler plug, drain plug, or dipstick before checking or draining any lubricant. This is especially important in dusty or sandy areas and when the vehicle is used on unpaved roads. Cleaning the plug and dipstick areas will prevent dirt and gr ...