Inspection |
1. |
Connect the GDS on the Data Link Connector (DLC). |
2. |
Measure the output voltage of the MAPS at idle and IG ON.
|
Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Disconnect the manifold absolute pressure sensor connector (A). |
3. |
Remove the installation bolt (B), and then remove the sensor from the surge tank. |
Installation |
|
|
1. |
Install in the reverse order of removal.
|
Hyundai Tucson (LM) 2010-2015 Service Manual: Alternator Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the drive belt.
(Refer to Engine Mechanical System - "Drive Belt")
3.
Disconnect the alternator connector (A) and the cable (B) from alternator "B" terminal.
4.
Pull out the through bolt an ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Rear Hub - Carrier Repair procedures
Removal
1.
Remove the rear wheel and tire (A) from rear hub.
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
Be careful not to damage to the hub bolts when removing the front wheel and tire (A).
2.
Remove the rear brake caliper mount ...