Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the HO2S connector. |
3. |
Measure resistance between the HO2S terminals 2 and 5 [B1/S1]. |
4. |
Measure resistance between the HO2S terminals 3 and 4 [B1/S2]. |
5. |
Check that the resistance is within the specification.
|
Removal |
[Bank 1 / Sensor 1] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Disconnect the connector (A), and then remove the sensor (B).
|
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Remove the console side cover (A). |
3. |
Disconnect the connector (A), and then remove the sensor (B).
|
Installation |
|
|
1. |
Install in the reverse order of removal.
|
Hyundai Tucson (LM) 2010-2015 Owners Manual: Selecting a Child Restraint System (CRS)
When selecting a CRS for your child, always:
Make sure the CRS has a label certifying that it meets applicable Federal
Motor Vehicle Safety Standards (FMVSS 213).
Select a child restraint based on your child’s height and weight. The required
label or the instructions for use typically ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Condenser Repair procedures
Inspection
1.
Check the condenser fins for clogging and damage. If clogged,
clean them with water, and blow them with compressed air. If bent,
gently bend them using a screwdriver or pliers.
2.
Check the condenser connections for leakage, and repair or replace it, if required.
Replace ...