Hyundai Tucson: Engine Control System / Accelerator Position Sensor (APS) Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Control / Fuel System / Engine Control System / Accelerator Position Sensor (APS) Repair procedures

Inspection

1.	Connect the GDS on the Data Link Connector (DLC).

2.	Turn the ignition switch ON.

Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.

Specification: Refer to “Specification”

Removal

1.	Turn the ignition switch OFF and disconnect the negative (-) battery cable.

2.	Disconnect the accelerator position sensor connector (A).

3.	Remove the installation nuts (B), the bolt (C) and then remove the accelerator pedal module.

Installation

Install in the reverse order of removal.

Accelerator pedal module installation nut:

16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)

Accelerator pedal module installation bolt:

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Accelerator Position Sensor (APS) Schematic Diagrams

Circuit Diagram (M/T) (A/T) ...

Fuel Tank Pressure Sensor (FTPS) Description and Operation

Description Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system and is installed on the fuel tank, the fuel pump, or the canister. It checks the purge con ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Repair procedures
Replacement Problems And Replacement Parts: ProblemPart setScan tool requiredxAll keys have been lostBlank key (4)YESAntenna coil unit does not workAntenna coil unitNOECM does not workPCM(ECM)YESIgnition switch does not workIgnition switch with Antenna coil unitYESUnidentified vehicle specific d ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Repair procedures
Fuel Pressure Test (Low pressure system) 1. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line") When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS ...