Hyundai Tucson: Engine Control System / Fuel Tank Pressure Sensor (FTPS) Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Control / Fuel System / Engine Control System / Fuel Tank Pressure Sensor (FTPS) Repair procedures

Inspection

1.	Connect the GDS on the Data Link Connector (DLC).

Measure the output voltage of the FTPS.

Specification: Refer to "Specification"

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Remove the rear seat. (Refer to Body - "Seat")

3.	Remove the fuel pump service cover (A).

4.	Disconnect the fuel tank pressure sensor connector (A).

5.	Remove the fuel tank pressure sensor after releasing the hooks vertically.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.

•	Insert the sensor in the installation hole and be careful not to damage when installation.

1.	Install in the reverse order of removal.

Fuel Tank Pressure Sensor (FTPS) Schematic Diagrams

Circuit Diagram (M/T) (A/T) ...

Injector Description and Operation

Description The GDI injector is similar to a standard injector, but sprays fuel at a much higher pressure directly into the combustion chamber and has a swirl disc to get the fuel swirling as i ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Reducing the risk of a rollover
Your multi-purpose passenger vehicle is defined as a Sports Utility Vehicle (SUV). SUV’s have higher ground clearance and a narrower track to make them capable of performing in a wide variety of off-road applications. The specific design characteristics give them a higher center of gravity t ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Automatic heating and air conditioning
When using the AUTO climate control mode, the fan speeds, mode selection, air intake control, and the air conditioning will be automatically controlled according to the desired temperature setting. To enable this mode, perform the following steps: 1. Push the AUTO button. 2. Set the t ...