Hyundai Tucson: Engine Control System / Purge Control Solenoid Valve (PCSV) Description and Operation

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Control / Fuel System / Engine Control System / Purge Control Solenoid Valve (PCSV) Description and Operation

Description

Purge Control Solenoid Valve (PCSV) is installed on the surge tank and controls the passage between the canister and the intake manifold. It is a solenoid valve and is open when the ECM grounds the valve control line. When the passage is open (PCSV ON), fuel vapor stored in the canister is transferred to the intake manifold.

Injector Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the injector connector. 3. Measure resistance between the injector terminals 1 and 2. 4. Check that the resistance is within t ...

Purge Control Solenoid Valve (PCSV) Specifications

Specification ItemSpecificationCoil Resistance (x)22.0 ~ 26.0 [20°C(68°F)] ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Water pump Repair procedures
Removal and Installation 1. Loosen the drain plug, and then drain the engine coolant. Remove the radiator cap to help drain the coolant faster. 2. Remove the drive belt. (Refer to Timing system in this group) 3. Remove the water pump pulley (A). Tightening torque: 9.8 ~ 11.8 N.m ( ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Yaw-rate and G Sensor Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the floor console. 3. Disconnect the yaw rate & lateral & Longitudinal G sensor connector (A). 4. Remove the mounting bolts (B). Tightening torque: 7.9 ~ 10.8 N.m (0.8 ~ 1.1 kgf.m ...