Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the CCV connector. |
3. |
Measure resistance between the CCV terminal 1 and 2. |
4. |
Check that the resistance is within the specification.
|
5. |
Disconnect the vapor hose connected with the canister from the CCV. |
6. |
Connect a vacuum pump to the nipple. |
7. |
Ground the CCV control line and apply battery voltage to the CCV power supply line. |
8. |
Apply vacuum and check the valve operation.
|
Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Lift the vehicle. |
3. |
Disconnect the canister close valve connector (A). |
4. |
Disconnect the ventilation hose (B,C) from the fuel tank air filter and canister close valve. |
5. |
Remove the fuel tank air filter and canister close valve assembly (A) after removing the mounting nut (B). |
6. |
Release the lever (A), and then separate the canister close
valve (B) from the fuel tank air filter (C) after rotating it in the
direction of the arrow in the figure. |
Installation |
|
1. |
Install in the reverse order of removal.
|
Hyundai Tucson (LM) 2010-2015 Owners Manual: 90,000 miles (144,000 km) or 72 months
Rotating tires
Inspect vacuum hose
Inspect air conditioning refrigerant
Inspect brake hoses and lines
Inspect drive shafts and boots
Inspect exhaust pipe and muffler
Inspect front brake disc/pads, calipers
Inspect propeller shaft (AWD)
Inspect rear brake disc/pads
Inspect steeri ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Components and Components Location
Component Location
Engine Room
1. Condenser2. Receiver-drier 3. Compressor 4. Expansion Valve5. Service port (High)6. Service port (Low)7. A/C Pressure Transducer
Interior
...