Removal |
1. |
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line") |
2. |
Remove the rear seat cushion.
(Refer to Body - “Seat”) |
3. |
Remove the fuel pump service cover (A). |
4. |
Disconnect the fuel pump connector (A) and the fuel tank pressure sensor connector (B). |
5. |
Disconnect the fuel feed tube quick connector (C). |
6. |
Remove the rear - LH wheel & tire. |
7. |
Lift the vehicle and support the fuel tank with a jack. |
8. |
Remove the center muffler assembly.
(Refer to Engine Mechanical System - “Intake And Exhaust System”) |
9. |
Remove the propeller shaft.
(Refer to Driveshaft and Axle - “Propeller Shaft Assembly”) [4WD] |
10. |
Disconnect the fuel filler hose (A) and the ventilation hose (B). |
11. |
Disconnect thd canister close valve connector (A). |
12. |
Disconnect the vapor tube quick-connector (A). |
13. |
Remove the fuel tank from the vehicle after removing the fuel tank band (A).
|
Installation |
1. |
Install in the reverse order of removal.
|
Hyundai Tucson (LM) 2010-2015 Service Manual: Purge Control Solenoid Valve (PCSV) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV terminals 1 and 2.
4.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Removal
1.
Turn the ignition switc ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Repair procedures
Operation and Leakage Check
Check all of the following items :
ComponentProcedureBrake Booster (A)Check brake operation by applying the brakes during a test
drive. If the brakes do not work properly, check the brake booster.
Replace the brake booster as an assembly if it does not work proper ...