Removal |
1. |
Remove the rear-LH wheel, tire, and the inner wheel house. |
2. |
Disconnect the fuel filler hose (A) and the ventilation hose (B). |
3. |
Open the fuel filler door and unfasten the filler-neck assembly mounting screw (A). |
4. |
Remove the filler-neck assembly from the vehicle after removing the bracket mounting nut (A). |
Installation |
1. |
Install in the reverse order of removal.
|
Hyundai Tucson (LM) 2010-2015 Service Manual: Coolant Repair procedures
Refilling And Bleeding
Never remove the radiator cap when the engine is hot. Serious
scalding could be caused by hot fluid under high pressure escaping from
the radiator.
When pouring engine coolant, be sure to shut the relay box
lid and not to ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Power Window Switch Repair procedures
Inspection
Main Power Window Switch Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim and power window switch.
(Refer to the BD group - "Front door")
3.
Check for continuity between the terminals in each switch
position according to the table. ...