Hyundai Tucson: Fuel Delivery System / Accelerator Pedal Repair procedures

Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the accelerator position sensor connector (A).

3.
Remove the installation nuts (B), the bolt (C) and then remove the accelerator pedal module.

Installation
1.
Install in the reverse order of removal.

Accelerator pedal module installation nut:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)
Accelerator pedal module installation bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Filler-Neck Assembly Repair procedures
Removal 1. Remove the rear-LH wheel, tire, and the inner wheel house. 2. Disconnect the fuel filler hose (A) and the ventilation hose (B). 3. Open the fuel filler door and unfasten the fil ...

Delivery Pipe Repair procedures
Removal     In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure f ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Transaxle Oil Temperature Sensor Description and Operation
Description Transmission Oil Temperature Sensor monitors the automatic transmission fluid's temperature and conveys the readings to TCM. It is an NTC (Negative Thermal Coefficient) sensor whose resistance has an inversely proportional relationship with the temperature level. Data produced ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Front Bumper Repair procedures
Replacement     • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage. • Take care not bend or scratch the cover and other parts. 1. Loosen the radiator upper cover mounting bol ...

© 2010-2024 www.htmanual.net