Hyundai Tucson: Clutch System / Clutch Cover And Disc Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Clutch System / Clutch System / Clutch Cover And Disc Repair procedures

Removal

1.	Remove the transaxle assembly. (Refer to "Manual transaxle system" in MT group)

Remove the clutch cover bolts.

•	Be careful not to be bent or twist bolts.

•	Loosen bolts in diagonal directions.

Inspection

1.	Inspect cover diaphragm spring wear which is in contact with clutch release cylinder or consentric slave cylinder bearing.

2.	Check the clutch cover and disc surface for wear or cracks.

3.	Check the clutch disc lining for slipping or oil marks.

Measure the depth from a clutch lining surface to a rivet. If the measured value is less than the specification below, replace it.

Standard value

Clutch disc thickness (A) [when free] : 8.7 ± 0.3 mm

Clutch disc rivet depth (B) : 1.1 mm (0.0433 in.)

Installation

If reinstalling used cover, the cover should be installed with its clutch disc as a set.

Apply grease on a disc spline part and transmission input shaft spline part as required.

* Possible problems when not following

-	When not applying: Excessive wear of splines and bad clutch operation can occur.

-	When excessively applying: Grease can be scattered by centrifugal force which can contaminate the clutch disc. This can cause a loss of friction force causing a slip.

The 'T/M SIDE' marked surface should face the engineer.

•	Possible problems when the disc is installed in the opposite direction.

•	Transaxle shift error or a strangesound can occur due to clutch separation.

3.	Install the clutch disc and the cover with SST (A: 09411-1P000).

Install the clutch cover bolts. Not to be bent or twisted, Tighten them in diagonal directions.

Tightening torque:

24.5 ~ 35.3 N.m (2.5 ~ 3.6 kgf.m, 18.1 ~ 26.0 lb-ft)

•	Loosely tighten every clutch cover bolts, then torque to specifications in a diagonal direction. This can prevent twisting, vibration of the cover, and the lifting of the pressure plate.

•	Install the all the components with the specified torques. If not, the clutch torque transaxle may have concerns or the mounting bolt can loosen.

5.	Install the transaxle assembly. (Refer to "Manual transaxle system" in MT group.)

Clutch Cover And Disc Components and Components Location

Components 1. Clutch disc2. Clutch cover3. Manual transaxle 4. Engine flywheel5. Clutch release bearing6. Clutch release fork ...

Clutch Pedal Components and Components Location

Components 1. Reverse hose2. Master cylinder3. Siller4. Member assembly5. Turn over spring6. Clutch switch7. Clutch arm8. Pedal pad9. Ignition lock switch10. Stopper ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Console Components and Components Location
Components [A/T] 1. Floor console2. Console upper cover (AT)3. Floor console tray4. Floor console bezel5. Extension side cover ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Transaxle Oil Temperature Sensor Description and Operation
Description Transmission Oil Temperature Sensor monitors the automatic transmission fluid's temperature and conveys the readings to TCM. It is an NTC (Negative Thermal Coefficient) sensor whose resistance has an inversely proportional relationship with the temperature level. Data produced ...