Hyundai Tucson: Clutch System / Clutch Release Cylinder Repair procedures
Hyundai Tucson (LM) 2010-2015 Service Manual / Clutch System / Clutch System / Clutch Release Cylinder Repair procedures
| Removal |
| 1. |
Drain the brake fluid through the bleed plug (A).
|
| 2. |
Remove the clutch release cylinder assembly (C) after removing thd tube (B) and bolts (A-2ea).
|
| Installation |
| 1. |
Installation is the reverse of removal.
|
| Adjustment |
| Clutch Release Cylinder Air Bleeding Procedure |
Use the specified fluid. Avoid mixing different brands of fluid. |
Specified fluid: SAE J1703 (DOT 3 or DOT 4) |
| 1. |
After disconnecting a cap from the clutch release cylinder air bleeder, insert a vinyl hose in the plug. |
| 2. |
Loosening the plug screw, press and release the clutch pedal about 10 times. |
| 3. |
Tighten the plug (A) during the clutch pedal pressed. Afterwards, raise the pedal with a hand. |
| 4. |
After pressing the clutch pedal 3 times more, loosen the plug
(A) and retighten it with the pedal pressed. Raise it again, then. |
| 5. |
Repeat the step 4 two or three times. (until there is no bubble in the fluid)
|
| 6. |
Refill the clutch master cylinder with the specified fluid. |
Clutch Release Cylinder Components and Components Location
Components
1. Union bolt2. Gasket3. Tube joint4. Clutch tube5. Valve plate6. Valve spring7. Bleeder screw8. Release cylinder9. Return spring10. Piston11. Boot12. Push rod
...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Rear Shock Absorber Components and Components Location
Components
1. Self locking nut2. Bracket assembly3. Bumper rubber4. Dust cover5. Shock absorber
...
Hyundai Tucson (LM) 2010-2015 Service Manual: Pressure Sensor Repair procedures
Inspection
If you have trouble code related to the pressure sensor check pressure sensor according to the inspection process.
Pressure Sensor Inspection Procedure
Measure the resistance of pressure sensor
1.
Turn ignition switch OFF.
2.
Disconnect the pressure ...
© 2010-2024 www.htmanual.net
