Hyundai Tucson: Hydraulic System / Fluid Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Automatic Transaxle System / Hydraulic System / Fluid Repair procedures

Service Adjustment Procedure

Oil level Check

A check of ATF level is not normally required during scheduled services. If an oil leak is found, perform the oil level check procedure after repairs are completed.

When checking the oil level, be careful not to enter dust, foreign matters, etc. from fill hole.

Remove the eyebolt (A).

Eyebolt tightening torque:

2.9 ~ 4.9 N.m (0.3 ~ 0.5 kgf.m, 2.2 ~ 3.6 lb-ft)

Always replace the gasket of the eyebolt use new one whenever loosening eyebolt.

2.	Add ATF SP-IV 700cc to the ATF injection hole.

3.	Start the engine. (Don’t step on brake and accelerator simultaneously.)

4.	Confirm that the temperature of the A/T oil temperature sensor is 50 ~ 60°C(122 ~ 140°F) with the GDS.

Shift the select lever slowly from “P” to “D”, then “D” to “P” and repeat one more at idle.

Keep on each speed position more than 2 sec.

Lift the vehicle, then remove the oil level plug (A) from the valve body cover.

At this time, the vehicle must be at a level state.

If the oil flows out of the overflow plug in thin steady stream, the oil level is correct.

Then finish the procedure and tighten the oil plug.

Oil level check (excess or shortage) method

•	Excess: Drain quantity exceed 900cc for tow minutes.{50 ~ 60°C (122 ~ 140°F)}

•	Shortage: No drain.

If there is no damage at the automatic transaxle and the oil cooler, the oil cooler hose, transaxle case, valve body tightening state are normal, ATF must drip out after performing above 1 to 7 procedures. After performing above 1 to 7 procedures, if the oil doesn’t drip out, inspect the automatic transaxle assembly.

Replace the gasket before reinstalling the oil level plug.

Oil level plug tightening torque:

Tightening up stopper

8.	Put down the vehicle with the lift and then tighten the eyebolt.

Replacement

ATF of 6 speed automatic transaxle doesn’t be replaced. But, if the vehicle is severe use or business use, replace ATF every 60,000 miles for severe usage.

Severe usage is defined as

•	Driving in rough road (Bumpy, Gravel, Snowy, Unpaved road, etc)

•	Driving in mountain road, ascent/descent

•	Repetition of short distance driving

•	More than 50% operation in heavy city traffic during hot weather above 32°C(89.6°F) .

•	Police, Taxi, Commercial type operation or trailer towing, etc

Remove the drain plug (A) and reinstall the drain plug after draining ATF totally.

Drain plug tightening torque:

38.2 ~ 48.1 N.m (3.9 ~ 4.9 kgf.m, 28.2 ~ 35.4 lb-ft)

Replace the gasket before reinstalling the drain plug.

2.	Fill the oil about 5 liters.

3.	Check the oil level. (Refer to Hydraulic System - "Fluid")

Fluid Components and Components Location

Components Location 1. Injection hole (eyebolt)2. Oil level plug3. Oil drain plug ...

Valve Body Description and Operation

Description The valve body is essential to automatic transaxle control and consists of various valves used to control the oil feed from the oil pump. Specifically, these valves ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Windshield Wiper-Washer Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper and lower shrouds (A) after removing 3 screws. Take care not to damage and scratch the shrouds and its related parts. Take care not to damage the hook when removing the upper ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Front seats
WARNING Take the following precautions when adjusting your seat: NEVER attempt to adjust the seat while the vehicle is moving. The seat could respond with unexpected movement and may cause loss of vehicle control resulting in an accident. Do not place anything under the front seats. Loo ...