Hyundai Tucson: Automatic Transaxle Control System / Output Speed Sensor Repair procedures

Inspection
1.
Check signal waveform of Input & output speed sensor using the GDS.

Specification: Refer to "Signal Wave Form" section.

Removal
1.
Remove the valve body assembly.
(Refer to Hydraulic System - "Valve Body")
2.
Disconnect the input & output speed sensor connector (A) from the main wiring.
3.
Remove the input & output speed sensor (B) after removing the bolts(2ea).

Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Installation
1.
Install in the reverse order of removal.
   
Adding coolant.
(Refer to Engine Mechanical System - "Coolant")
Adding Automatic Transaxle Fluid(ATF).
Output Speed Sensor Troubleshooting
Signal Waveform Fig 1) Input/Output speed sensor at low speed Fig 2) Input/Output speed sensor at high speed ...

Torque Converter Control Solenoid Valve (T/CON_VFS) Description and Operation
Description Torque converter control solenoid valve (T/CON_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the torque conv ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Jack and tools
➀ Jack handle ➁ Jack ➂ Wheel lug nut wrench The jack, jack handle, and wheel lug nut wrench are stored in the luggage compartment under the luggage box cover. The jack is provided for emergency tire changing only. Remove the luggage floor support (1) by pulling it out. Turn the wing ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: 90,000 miles (144,000 km) or 72 months
Rotating tires Inspect vacuum hose Inspect air conditioning refrigerant Inspect brake hoses and lines Inspect drive shafts and boots Inspect exhaust pipe and muffler Inspect front brake disc/pads, calipers Inspect propeller shaft (AWD) Inspect rear brake disc/pads Inspect steeri ...

© 2010-2024 www.htmanual.net