Inspection |
1. |
Turn ignition switch OFF. |
2. |
Disconnect the solenoid valve connector. |
3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
4. |
Check that the resistance is within the specification. |
Removal |
Replacing an on/off solenoid valve (SS-A, SS-B) does not
require additional hydraulic pressure adjustment; however, the hydraulic
pressure will need to be adjusted after replacing the VFS solenoid
valve. If replacing the VFS solenoid valve; also replace the valve body
assembly.
(Refer to Hydraulic system - "Valve Body") |
Hyundai Tucson (LM) 2010-2015 Service Manual: Components and Components Location
Components
1. Sub frame2. Steering gearbox3. Front stabilizer bar4. Front lower arm5. Front axle6. Front strut assembly7. Drive shaft
...
Hyundai Tucson (LM) 2010-2015 Service Manual: Water pump Troubleshooting
Troubleshooting
Water Pump
SymptomsPossible CausesRemedyCoolant leakage
•
From the bleed hole of the water pump
Visually check
•
Check leaks after about ten-minute warming up.
•
If coolant still leaks, replace a water pump.
•
If leakage stops, reuse the water pump (D ...