Hyundai Tucson: Automatic Transaxle Control System / SS-A Solenoid Valve(ON/OFF) Repair procedures

Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the resistance is within the specification.
Removal
1.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "Air cleaner")
2.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
3.
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
4.
Remove the drain plug (A) and reinstall the drain plug after draining ATF totally.

Drain plug tightening torque :
38.2 ~ 48.1 N.m (3.9 ~ 4.9 kgf.m, 28.2 ~ 35.4 lb-ft)

   
Replace the gasket before reinstalling the drain plug.
5.
Disconnect the air breather hose (A) from the valve body cover after disconnecting the clamp (B).

6.
Remove the valve body cover (A).

Tightening torque :
(B) 13.7 ~ 15.7 N.m (1.4 ~ 1.6 kgf.m, 10.1 ~ 11.6 lb-ft)

7.
Remove the bolts.
8.
Disconnect the solenoid valve connector (B) and the oil temperature sensor (A) from the valve body.

Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

9.
Remove the solenoid valve support bracket (A).

Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

10.
Remove the torque converter control solenoid valve (A).

Installation
1.
Installation is the reverse of removal.
   
When installing, apply the ATF oil or white vaseline to the O-ring (A) not to be damaged.

Replace the valve body gasket (A) before reinstalling the valve body cover.

Adding automatic transaxle fluid.
(Refer to Hydraulic system - "Fluid" )
Perform TCM learning after replacing the automatic transaxle to prevent slow automatic transaxle response, jerky acceleration and jerky startup.
(Refer to "Automatic transaxle control system - "Repair procedures")
SS-A Solenoid Valve(ON/OFF) Schematic Diagrams
Circuit Diagram ...

SS-B Solenoid Valve(ON/OFF) Description and Operation
Description SS-B solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears. SS-B Solenoid valve(ON/OFF) is installed at valve body. ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Description and Operation
Description Ignition timing is controlled by the electronic control ignition timing system. The standard reference ignition timing data for the engine operating conditions are pre-pro grammed in the memory of the ECM (Engine Control Module). The engine operating conditions (speed, load, wa ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Air cleaner
Filter replacement The air cleaner filter can be cleaned for inspection using compressed air. Do not attempt to wash or to rinse it, as water will damage the filter. If soiled, the air cleaner filter must be replaced. 1. Loosen the air cleaner cover attaching clips and open the cover. ...

© 2010-2024 www.htmanual.net