Hyundai Tucson: Automatic Transaxle Control System / Inhibitor Switch Description and Operation

Hyundai Tucson (LM) 2010-2015 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Inhibitor Switch Description and Operation

Description

Inhibiter Switch contains two contact points. One of these points connects the engine startup when the lever is in the N or P position and turns on the reverse lights. The other contact point monitors the lever's position (PRND) and is used to control gear setting signals.

SS-B Solenoid Valve(ON/OFF) Repair procedures

Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the ...

Inhibitor Switch Specifications

Specifications x Type: Combination of output signals from 4 terminals Power supply (V)12Output typePin to Pin Signal Code Table PP-RRR-NNN-DDS112V12V00000S2012V12V12V000S300012V12V12V0S ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Troubleshooting
Troubleshooting Trouble SymptomProbable causeRemedyVehicle pulls to one sideScoring of driveshaft ball jointReplaceWear, rattle or scoring of wheel bearingReplaceDefective front suspension and steeringAdjustment or ReplaceVibrationWear, damage or bending of driveshaftReplaceDriveshaft rattle an ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Troubleshooting
Troubleshooting Ignition System SymptomSuspect AreaRemedyEngine will not start or is hard to start (Cranks OK) Ignition lock switchInspect ignition lock switch, or replace as requiredIgnition coilInspect ignition coil, or replace as requiredSpark plugsInspect spark plugs, or replace as requi ...