Hyundai Tucson: Automatic Transaxle Control System / Shift Cable Repair procedures

Removal
1.
Remove the console.
(Refer to Body - "Floor console")
2.
Disconnect the shift cable (A) from the shift lever.

3.
Remove the shift cable assembly in the vehicle after removing the nuts (B) and the retainer (A).

Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

4.
Remove the nut (C) from the manual control lever.

Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

5.
Remove the cable (B) from the bracket (A) at transaxle assembly side.
6.
Remove the shift cable by pulling it toward the interior.

Installation
1.
Install in the reverse order of removal.
   
When installing, Set shift lever and inhibitor switch manual control lever to "N" position.
Adjustment
Adjusting method for T/M control cable
1.
Set room side shift lever and T/M side manual control lever to "N" position.
2.
Connect room side shift lever and shift cable.
3.
Push cable to "F" direction shown to eliminate FREE PLAY.
4.
Tighten adjusting nut (A).

Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

5.
After adjusting according check to be sure that this part operates surely at each range of T/M side correspond.
Shift Cable Components and Components Location
Components 1. Shift lever knob 2. Shift lever assembly3. Shift cable4. Manual control lever5. Shift cable retainer ...

4 Wheel Drive (4WD) System
...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Trip Modes
Push the button to select the following modes:   Tripmeter This mode indicates the distance of individual trips selected since the last tripmeter reset. The meter's working range is from 0.0 to 999.9 miles (0.0 to 9999.9 km). Pressing the TRIP button for more than 1 second, whe ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Blower Motor Repair procedures
Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor voltage is not operated well, substitute with a known-good blower motor and check for proper operation. 3. If the problem is corrected, replace the blower motor. Replacement 1. Di ...

© 2010-2024 www.htmanual.net