Hyundai Tucson: Transfer Assembly / Transfer Fluid Repair procedures

Inspection
   
Transfer oil should be inspected and refilled every 60000 km (40000 mile) / 4 year.
1.
Remove the under cover (A).

2.
Remove the oil filler plug (A).

3.
Check the oil level.
   
Oil level must be up to fill the hole, if not, add oil until it runs over.

4.
Install the oil filler plug with new gasket.

Tightening torque :
39.2~58.8N.m (4.0~6.0kgf.m, 28.9~43.4lb-ft)

5.
Install the under cover.

Tightening torque :
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

Replacement
   
Change 
Normal Use
Severe Use
No service required
120000 km
(80000 miles)

Severe driving conditions
1.
Driving in dusty, rough roads
2.
Drivng in mountains areas
3.
Driving for patrol car, taxi, commercial car or vehicle towing
4.
Driving over 170Km/h
* Transfer oil should be replaced if the transfer assembly is fall into the water.
1.
Remove the under cover (A).

2.
Drain the transfer oil after loosening the drain plug (A).

3.
Install the drain plug with new gasket.

Tightening torque :
58.9~78.5N.m (6.0~8.0kgf.m, 43.4~57.9lb-ft)

4.
Remove the oil filler plug (A).

5.
Add new oil through the filler plug hole.

Standard oil : Hypoid gear oil API GL-5, SAE 75W/90 (SHELL SPIRAX X or equivalent)
Oil capacity :
Diesel 2.0 / 2.2, Gasoline 2.4: About 0.6 L (0.16 U.S.gal., 0.63 U.S.qt, 0.53 Imp.qt.)
Gasoline 3.0 / 3.3: About 0.68 L(0.18 U.S.gal, 0.72 U.S.qt, 0.60 lmp,qt)

   
Filled up to lower filler plug thread level.

6.
Install the oil filler plug with new gasket.

Tightening torque :
39.2~58.8N.m (4.0~6.0kgf.m, 28.9~43.4lb-ft)

7.
Install the under cover.

Tightening torque :
7.8 ~ 9.8N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

Transfer Assembly
...

Front Wheel Transfer Assembly Components and Components Location
Components Location 1. Transaxle Assembly2. Transfer assembly3. Propeller shaft4. Coupling assembly ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Rear Seat Components and Components Location
Components 1. Headrest2. Headrest guide3. Upper bezel4. Tether anchor garnish5. Armrest cover6. Seat back cover7. Armrest8. Seat cushion cover9. Seat warmer10. Seat cushion pad ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Front Hub / Knuckle / Tone Wheel Repair procedures
Removal 1. Remove the front wheel and tire (A) from front hub . Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)     Be careful not to damage to the hub bolts when removing the front wheel and tire (A). 2. Remove the brake caliper mounting ...

© 2010-2024 www.htmanual.net