Hyundai Tucson: Coupling Assembly / Pressure Sensor Repair procedures

Inspection
   
If you have trouble code related to the pressure sensor check pressure sensor according to the inspection process.
Pressure Sensor Inspection Procedure

Measure the resistance of pressure sensor
1.
Turn ignition switch OFF.
2.
Disconnect the pressure sensor connector.
3.
Measure resistance between sensor terminal and terminal.
4.
Check the measured resistance. (Refer to table)
Terminal
Resistance
PIN 2 – PIN 3
2.755 ~ 4.133 kx
PIN 1 – PIN 3
1.892 ~ 2.838 kx
PIN 1 – PIN 2
1.714 ~ 2.838 kx

Removal
1.
Remove the coupling assembly.
(Refer to Coupling Assembly - " Removal ")
2.
Remove the extension Cable (A).

3.
Remove the pressure sensor (A) with 24mm socket.
   
Keep going horizontal state to prevent leaks during remove the pressure sensor.

Tightening torque:
7.8 ~ 9.8 N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2 lb-ft)

Installation
   
Check the cleanliness of the pressure sensor before installation.
Check the pressure sensor O-ring (A).

1.
Install in the reverse order of removal.
Pressure Sensor Schematic Diagrams
Circuit Diagram ...

Driveshaft and axle
...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Aux, USB and iPod® port (if equipped)
If your vehicle has an aux and/or USB(universal serial bus) port or iPod port, you can use an aux port to connect audio devices and the USB port to plug in a USB device. Both ports are used together with the accessory iPod cable to connect an iPod. ✽ NOTICE When using a portable audio d ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Thermostat Repair procedures
Removal and Installation     Disassembly of the thermostat would have an adverse effect, causing a lowering of cooling efficiency. Do not remove the thermostat, even if the engine tends to overheat. 1. Drain engine coolant so its level is below thermostat. 2. Disconn ...

© 2010-2024 www.htmanual.net